If your bounce house has a hole, there are several methods you can use to find it. However, for smaller leaks, it can be harder to locate. If there is any air escaping from the bounce house where it shouldn’t be, walk around it while it is inflated and running.You can visit this website for anything relative to bounce house https://www.3monkeysinflatables.com
Ways To Find A Leak:
- Feel for escaping air
- Invest in submerging in water (only feasible for small models)
- Put the soapy water on it.
- You can hear air escaping
Most bounce houses are too big to submerge in water and you can’t hear where the air is escaping. Although you may have access to a large pool, it is still a hassle. I do not recommend it.
Look for areas on the bounce house that are deflating faster than others and start stepping back. It is during this walk around that you are trying to determine where the leak is located. For those next steps, it is helpful to identify a general area.
As you walk about the bounce house examining it, place your hand close to it. This will allow you to feel large leaks easily.
You may have to coat the bounce house with soapy water if you’re unable to locate the leak by feel. Covering the leak with soapy water will create bubbles. Deflate the area on the bounce house that you determined to deflate more rapidly earlier.
Make soapy water like this to ensure better retention:
- 1/3 Cup dish soap
- 1 Tbsp glycerin
- 1 Gallon of water
Use a couple of square feet of the coated bounce house at a time to coat the bounce house. We have applied the same steps without glycerin, using soap and water, and were successful in finding a small leak. With glycerin, the soap stays together longer and makes the bubbles bigger, making finding the leak easier.
It is critical that you let the bounce house dry for 4-5 hours before storing it if you do use a lot of water on it.
A Bounce House Needs A Quick Repair
I understand that you have asked yourself to just cover the leak with duct tape and call it a day of bliss. That didn’t work very well for me before; I tried it before. On smaller bounce houses, duct tape might work relatively well, but after all, it’s just a temporary fix.
The vinyl repair tape will cover the leak quickly enough to fix the leak. The duct tape fix did not work well for us, but this has been more successful than any other solution. A smaller bounce house would work great with this. In practice, however, the tape starts pulling up on itself after a while, allowing air to leak out once again.
0 Comments